Mounting - SMART ebike Owner's Manual

X
Alternately tighten screws : to a torque
of 6 Nm (4.43 lb-ft).
X
Alternately tighten both rear handlebar
clamp screws ; to 6 Nm (4.43 lb-ft).
X
After riding for 30 km (19 miles), re-
tighten screws : and ; to the specified
torque of 6 Nm (4.43 lb-ft).
Mounting the stem face plate
X
Insert the control console contact plate.
X
Slide the face plate onto the stem.
X
Push the contact plate down completely.
X
Insert the contact plate screw and
tighten to a torque of 1 Nm (0.74 lb-ft).
X
Insert the electrical connectors for the
data cable and the sensor cable into the
contact plate.
X
Insert the control console (
X
Check whether the lamp is on and all the
information is displayed on the control
console display.
X
Take a test ride to check that braking
assistance is working when the front
wheel brake is applied.
Y
page 25)
Stowing and features
33
Z