Fitting The Battery; Battery Holder - SMART ebike Owner's Manual

Removing/fitting the battery
42
X
Switch off the system (
X
On the right-hand side of the ebike:
unlock battery lock : with key ;.
The lock cylinder in battery lock :
moves out and battery ? is unlocked 1.
X
On the left-hand side of the ebike: hold
recess = and lift battery ? slightly and
remove it from the side.
X
Place the rubber cap over the connector
in the battery holder.
Storing the battery
! Always place the battery on a solid base
with the charge socket facing upwards.
The charge socket and the connector plug
to the battery holder could otherwise
become damaged.
Installing the battery
G
WARNING
If the battery's lock cylinder does not
engage properly, the battery is not
secured. The battery could fall out of the
battery holder while you are riding the
bike. There is a risk of an accident.
Always install the battery as described in
the instructions and make sure that the bat-
tery has been locked.
Y
page 25).
Battery holder guide rails
Battery guide pins
Battery
:
Battery lock
;
X
Place battery : in position with the
guide pins on the guide rails.
X
Allow battery : to slide downwards
slowly.
X
Press in the lock cylinder of battery
lock ; until you hear it engage.
Battery : is now locked and secured.
The lock cylinder can also be pressed in
without inserting the key in the lock.
i
The lock cylinder cannot be pressed in
if the battery is not correctly positioned
on the guide rails. In this case, insert
the battery again.
X
Remove the key from battery lock ;.