Removing/Fitting The Battery; Connecting - SMART ebike Owner's Manual

hibited to ride a bicycle without a func-
tioning lighting system.
Connecting the charger
! Do not turn the pedals when charging
the battery while installed. Otherwise,
the charging socket on the battery may be
damaged.
Battery
:
Charge socket with LED ring
;
Charge cable connector
=
The battery can be charged either on the
bike or can be removed and charged sepa-
rately.
When the battery is charged on the bike, the
system can be switched on or off during
charging.
X
Connect the charger to charge cable con-
nector = on battery :.
X
Connect the charger's mains plug to a
socket.
LED ring ; around the charge socket on
battery : lights up depending on the
charge level and then changes to orange.
Battery : is being charged.
i
It takes approx. 5 hours for the battery
to fully charge. Once the battery is fully
charged, the LED ring colour changes
from orange to green.
When charging the battery on the bike,
you can switch on the system if you wish
to check the current battery charge level.

Removing/fitting the battery

The control console displays the current
charge level.
X
First disconnect charge cable connector
= from battery : and then remove the
mains plug from the socket.
Removing/fitting the battery
Removing the battery
On the right-hand side of the ebike, when viewed
in the direction of travel: unlock the battery
On the left-hand side of the ebike, when viewed
in the direction of travel: remove the battery
from the battery holder
Locked
g
Unlocked
1
Battery lock
:
Key
;
Recess
=
Battery
?
41
Z