Hot-Swap Scsi Drives; Checking A Hot-Swap Scsi Drive Status Indicator; Removing Dimms; Hot-Swap Scsi Drive Bay And Status Indicators - MAXDATA PLATINUM 7200 Product Manual

Hot-Swap SCSI Drives

Hot-swap drives are installed in carriers that fit into the hot-swap drive bay. This section
describes the LED status indicators for the drive bays and gives instructions for using the
drive carriers to install and remove drives.

Checking a Hot-Swap SCSI Drive Status Indicator

Each hot-swap SCSI drive slot has an LED that indicates drive status (Figure 6). To view the
LEDs, open the access door on the right side of the bezel.
Figure 5. Hot-Swap SCSI Drive Bay and Status Indicators
A.
B.
Table 5 lists the LED states and the drive status indicated by each state.
MAXDATA PLATINUM 7200 Server
Figure 4. Removing DIMMs
�
�
Bezel
Access door, hot-swap drive bay
�
C.
LED status indicators
31