Removing A Power Supply Module; Installing A Power Supply Module - MAXDATA PLATINUM 7200 Product Manual

Removing a Power Supply Module

To remove a power supply module:
1. Remove the bezel.
2. Loosen the captive screw that retains the power supply module.
CAUTION
To avoid damaging the module, do not tilt or twist the power supply module as you pull it
from the power supply bay. The module disengaging from its connector causes the initial
resistance you will feel. Use even, steady force to remove the supply.
3. While pressing down on the locking tab, grasp the handle and carefully pull the
module out of the power supply bay.
4. If you are not going to install a replacement module, you must install a filler panel in the
vacant slot.
5. Install the bezel.

Installing a Power Supply Module

To install a power supply module:
1. Remove the bezel .
2. If present, remove the filler panel from the vacant slot.
3. Slide the power supply module into the vacant slot until you feel resistance.
36
�
�
�
Figure 11. Removing a Power Supply Module
A.
Power supply module
B.
Captive screw
�
C.
Locking tab
D.
Handle
Installing and Removing Components