Table of Contents
Advertisement
4 Installing and Removing
Removing and Installing the Bezel
You need to remove the bezel to install and remove hot-swap power supplies and to install
and remove devices in the 5.25-inch peripherals bay. The bezel has ball studs on the back
that snap-fit into holes on the chassis front.
•
To remove the bezel, pull it away from the chassis until the ball studs release from the
chassis.
•
To install the bezel, align the ball studs with the holes in the chassis and push gently
until the ball studs snap into the holes.
Memory
Installing DIMMs
CAUTION
Use extreme care when installing a DIMM. Applying too much pressure can damage the
socket. Keyed DIMMs insert only one way.
NOTE
Load the DIMMs in the following order (Figure 3).
1. Bank 1: DIMMs #1, 2, 3, and 4
2. Bank 2: DIMMs #5, 6, 7, and 8
3. Bank 3: DIMMs #9, 10, 11, and 12
Always fill banks completely. Partially filled banks are ignored by the system.
MAXDATA PLATINUM 7200 Server
�
Figure 2. Attaching the Bezel to the Chassis
�
29
Advertisement
Table of Contents
