Removing The Chassis Cover; Installing 5.5-Inch Drive (Dvd, Streamer); Installing Sata Or Sas Hot Swap Drives - MAXDATA PLATINUM 200 I User Manual

Removing the Chassis Cover

1. Remove the cover.
. Loosen the three thumbscrews that fasten the left front cover to the chassis.
. Pull the cover outwards (approx. 1 cm) so that the guiding hooks can slide out of the chassis
grooves.
4. Tilt the chassis cover upwards on its side and then take it off.
Installing 5.25-inch Drive (DVD, streamer)
The server is supplied with a total of six mounting rails for 5.5-inch devices. Unused mounting rails
can be found on the chassis beside or above the assembly areas of the drive cages.
1. Remove chassis cover.
. Unscrew two drive rails from their storage place beside the drive cages.
. Attach one drive rail each to the both left and right sides of the drive. The green handles should
face outwards.
4. Remove the blank cover from the relevant 5.5-inch bay (chassis and bezel).
5. Finish inserting the drive into the bay until the drive rails lock into place.
6. Connect the drive to the power supply and data cable according to the manufacturer's
instructions.
7. Replace the chassis cover and reconnect the bezel assembly.
To remove a 5.5-inch drive, push the green handles inwards towards the mounting rails and pull the
drive and rails forwards.

Installing SATA or SAS Hot Swap Drives

1. Press in on the green latch (letter "A") at the end of the drive carrier to disengage it from
the hot swap drive cage. Pull out on the black lever (letter "B") to fully open the drive carrier.
When the lever reaches a fully opened position, it will push the drive carrier out from the hot
swap drive cage.
14 14
Figure 7. Releasing Drive Carrier from Hot Swap Cage
Hardware Installations and Upgrades Hardware Installations and Upgrades