Table of Contents
Advertisement
Peripherals
Hot-Swap SCSI Hard Disk Drive Support
The hot-swap hard disk drive carrier accommodates 15,000-RPM or slower Ultra320 SCSI SCA-type
hard disk drives.
The SCSI Backplane Board supports Low Voltage Differential (LVD) SCSI disk drives only. Single-
Ended (SE) SCSI devices are not supported internally. SE drives are only supported on the external
SCSI connector.
Table 10. Hard Disk Drive Carrier
Item
A
B
Removable Media Drive Bay Support
The DVD-ROM/CD-ROM drive is installed in a sheetmetal carrier and is inserted from the front of the
chassis. The tape back-up drive is also installed from the front of the chassis. You must power down
the platform and remove the top cover to remove or install these devices.
5 ¼-inch Half-height Drive Bay
The system supports a single 5 ¼" half height device mounted in the front of the chassis. A SCSI
tape backup device could be used and cabled to the SCSI Channel B on the Main Board.
MAXDATA PLATINUM 7200 IR M6
MAXDATA PLATINUM 7200 IR M6
A
B
Figure 7. Hard Disk Drive Carrier
Description
Latch
Dual-color activity LED:
• Green flashing: Indicates hard drive is active.
• Amber and green alternating flashing: Indicates hard drive is powered
on and is rebuilding RAID, or it is powered on and has a fault condition.
• Amber flashing: Indicates hard drive is not powered on and has a fault
condition.
• Unlit: Indicates no hard drive is installed in that location or a drive is
installed, but no drive activity is taking place.
27
27
Advertisement
Table of Contents
