Install Hot Swap Drive; Removing Plastic Retention Device - MAXDATA PLATINUM 3200 I User Manual

7. Repeat steps 4-5 f­or installation of­ additional hard drives into drive cage.
8. Close the lower door of­ drive cage.
9. Close the upper door of­ drive cage.
10. Tighten the thumb screw. Install power and data cables to connectors on hard drive(s).
Install Hot Swap Drive(s)
1. Press in on the green latch (letter "A") at the end of­ the drive carrier to disengage it f­rom
the hot swap drive cage. Pull out on the black lever (letter "B") to f­ully open the drive carrier.
When the lever reaches a f­ully opened position, it will push the drive carrier out f­rom the hot
swap drive cage.
. Slide the drive carrier out of­ the drive cage.
. Remove the f­our screws that secure the plastic retention device to the drive carrier. Remove
the plastic retention device.
0
Figure 16. Releasing Drive Carrier from Hot Swap Cage
Figure 17. Removing Plastic Retention Device
Setting up the Chassis