Installing And Removing A Hard Disk Drive; Installing Hot-Swap Hard Disk Drive; Removing A Hot-Swap Hard Drive Carrier From Chassis; Removing The Retention Device From A Hot-Swap Drive Carrier - MAXDATA PLATINUM 1500 IR M5 User Manual

Installing and Removing a Hard Disk Drive

Installing Hot-swap Hard Disk Drive

1. Remove the front bezel if it is installed
2. Press in on the green latch at the front of the hard drive carrier. See letter "A" in the figure
below.
3. Pull out on the black lever and slide the carrier from the chassis. See letter "B" in the figure
below.
Figure 12. Removing a Hot-swap Hard Drive Carrier from Chassis
a
4. Remove the four screws that attach the plastic retention device or the previously installed hard
drive to the drive carrier. Two screws are at each side of the retention device or the hard drive.
Store the plastic retention device for future use.
Figure 13. Removing the Retention Device from a Hot-swap Drive Carrier
a
MAXDATA Server PLATINUM 1500 IR M5
�
27