Punching File Holes In Copies / Folding Copies (Fd-501) - Konica Minolta BIZHUB PRO 1050 Operator's Manual

Setting Output Methods
9.6 Punching File Holes in Copies / Folding Copies
(FD-501)
There are three elements for output settings:
- Intermediary processing
- Output mode
- Output tray position
The FD-501 Folding Unit does the intermediary processing, while FS-503
Finisher sets an output mode and changes output tray position.
The following punch/folding patterns are available:
- Punch:
2 or 4 holes can be punched in sheets for filing purposes. Set left/right/
top position according to the placement of sheets.
- Folding:
Six folding types are available - Z-Fold, Letter Fold-in, Letter Fold-out,
Double Parallel, Gate, and Folding. Choose to print outside the fold (out-
side print) or inside (inside print) for each folding mode except Z-fold.
This section describes how to set intermediary processing for punching
holes in copies and folding copies.
80 mm
80 mm
bizhub PRO 1050
Z-Fold Letter Fold-out
Letter Fold-in Double Parallel
9
Gate
Folding
9-27