Remove the warming or storage drawer to gain access to the
lower section of the range. This will be necessary for some of the
following installation steps.
To Remove Warming
Drawer:
1. Open drawer to its fully open position.
2. Locate the black loops on both sides of the drawer.
3.
A
A. Loop
Pull both loops forward at the same time, then pull drawer out
another inch.
IMPORTANT: On models with a warming drawer, the rear range
foot must be viewed from the front and slightly to one side of the
range,
1. Making sure the anti-tip bracket is installed:
•
Look for the anti-tip bracket securely attached to floor.
•
Slide range back so rear range foot is under anti-tip
bracket.
2.
If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements"
section.
4.
Holding the drawer by its sides, not its front, gently pull it all
the way out.
Place rack in oven. Place level on rack and check levelness of the
range, first side to side; then front to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
Use a wrench or pliers to adjust leveling legs up or down until the
range is level. Push range back into position. Check that rear
leveling leg is engaged in the anti-tip bracket.
NOTE: Range must be level for satisfactory
baking performance.
12