4.
Connect the neutral (center) wire to the center terminal
connector using one of the hex washer head screws.
Securely tighten screw for proper electrical connection.
E
D
F
C
G
o
H
3. Connect the other 2 wires (lines 1 and 2) to the outer terminal
screws on the terminal block.
4. Tighten strain relief screws.
5. Replace terminal block cover.
Direct Wire Installation:
Copper or Aluminum
Wire
This range may be connected directly to the fuse disconnect
or
circuit breaker box. Depending on your electrical supply, make
the required 3-wire or 4-wire connection.
1. Strip outer covering back 3" (7,6 cm) to expose wires. Strip
the insulation back 1" (2.5 cm) from the end of each wire.
1"
A. Line !
B. Green ground wire
C. Ground-link
screw
D. Hex washer head screw
E. Silver-colored
terminal
block screw
E Ground-link
G. Neutral (center) wire
H. Line 2
L UL listed strain relief and
40-amp range power
supply cord
5. Connect the other 2 wires (lines 1 and 2) to the outer
aluminum terminal blocks.
6. Securely tighten screws for proper electrical connection.
7. Tighten strain relief screws.
8. Replace terminal block cover.
3-wire connection:
Power Supply Cord
Use this method only if local codes permit connecting cabinet-
ground conductor to neutral wire of power supply cord,
1. Use a 1/4" nut driver and remove the hex washer head screws
from the aluminum terminal blocks,
2. Connect the neutral (center) wire to the center terminal
connector using one of the hex washer head screws.
Securely tighten screw for proper electrical connection.
B
F
A. Line 1
B. Ground-link
C. Hex washer head screw
D. Silver-colored
terminal
block screw
E. Neutral (center) wire
F. Line 2
G. UL listed strain relief
and 40-amp range power
supply cord
(7.6
crn)
2. Allow enough slack in the wire to easily attach the wiring
terminal block,
3. Complete electrical connection according to your type of
electrical supply (4-wire or 3-wire connection).
4-wire Connection:
Direct Wire
Use this method for:
•
New branch-circuit
installations (1996 NEC)
•
Mobile homes
•
Recreational vehicles
•
In an area where local codes prohibit grounding through the
neutral
1. Remove the ground-link
screw from the range frame, Save
the ground-link
screw and cup washer. Bend the ground-link
away from the range so that it does not contact the range,
A. Ground-link screw
B. Cup washer
C. Ground-link bent away from range
15