Table of Contents
Advertisement
Chapter 2 Installation
2.1
Hardware Installation
In the rear panel, there is a reset button. To load the factory default settings, hold
the reset button down for at least 5 seconds. If held down for more than 12 seconds,
the VoIP IAD will go into firmware update state and the user can update the VoIP
IAD from web-interface @192.168.1.1 without ID/Password.
Reset button
Follow the instructions below to complete the hardware connections.
Connection to ADSL port
Connect the ADSL line to the ADSL port with a RJ11 connection cable.
Connection to LAN port
To connect to a hub or PC, use a RJ45 cable. You can connect the VoIP IAD to up to
four LAN devices. The ports are auto-sensing MDI/X and either straight-through
cable or crossover cable can be used.
Connect the telephone set to the RJ11 Phone1/ Phone2 port for VoIP service.
11
Advertisement
Table of Contents
