Table of Contents
Advertisement
Chapter 2 Installation
2.1 Hardware Setup
Follow the instructions below to complete the hardware setup.
BACK PANEL
The figure below shows the back panel of the device.
1.2
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to the
power port. Attach the power adapter to a wall outlet or other AC source. Press the
power button to the ON position (IN). If the Power LED displays as expected then
the device is ready for setup (see section
Caution 1:
Caution 2:
Reset Button
Restore the default parameters of the device by pressing the Reset button for 5 to
10 seconds. After the device has rebooted successfully, the front panel should
display as expected (see section
NOTE:
Ethernet (LAN) Ports
Use 10/100 BASE-T RJ-45 cables to connect up to four network devices. These ports
are auto-sensing MDI/X; so either straight-through or crossover cable can be used.
Gb ETH Port
Use RJ45 straight through or crossover MDI/X cable to connect to Ethernet WAN.
DSL Port
PDF created with pdfFactory Pro trial version
DSL Port
If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely and then power it on again. If the
problem persists, contact technical support.
Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.
If pressed down for more than 20 seconds, the NEXUSLINK 3111u will go
into a firmware update state (CFE boot mode). The firmware can then
be updated using an Internet browser pointed to the default IP address.
Ethernet (LAN) Ports
Ethernet (LAN) Ports
2.2 LED
Indicators).
2.2 LED
Indicators for details).
8
www.pdffactory.com
Power Button
Power Port
Reset Button
Advertisement
Table of Contents
