Comtrend Corporation CT-6382D User Manual page 72

Traffic Class Name
Assign ATM Transmit Priority
Mark IP Precedence
Mark IP Type Of Service
Mark 802.1p if 802.1q is enabled on WAN
SET-1
Physical LAN Port
Protocol
Source IP Address
Source Subnet Mask
Source Port (port or port:port)
Destination IP address
Destination Subnet Mask
Destination port (port or port:port)
SET-2
802.1p Priority
Enter name for traffic class.
Select Low, Medium or High.
Select between 0-7. The lower the digit
shows the higher the priority.
Select either: Normal Service, Minimize
Cost, Maximize Reliability, Maximize
Throughput, Minimize Delay
Select between 0-7. The higher the
digit shows the higher the priority.
Select between ENET(1-4), USB,
Wireless and Wireless_Guest.
User can select from: TCP, TCP/UDP,
UDP or ICMP.
Enter the source IP address.
Enter the subnet mask for the source IP
address.
Enter source port number or port
range.
Enter destination IP address.
Enter destination subnet mask.
Enter destination port number or port
range.
Select between 0-7. The lower the digit
shows the higher the priority
71