Table of Contents
Advertisement
Chapter 2
2.1
Hardware Installation
In the rear panel, there is a reset button. It is used to load the factory default
settings.
Hold down the button until the LED's start blinking simultaneously (about
5 seconds). After the device has booted successfully, the factory default settings are
retrieved.
Follow the instructions below to complete the hardware connections.
Connection to LINE port
If you wish to connect both the router and a telephone, connect the LINE port to a
POTS splitter with a RJ11 connection cable.
Connection to LAN port
To connect to a hub or PC, use a RJ45 cable. You can connect the router to up to
four LAN devices. The ports are auto-sensing MDI/X and either straight-through
cable or crossover cable can be used.
Connection to Power
Connect the Power jack to the shipped power cord. Attach the power adapter to the
wall outlet or other AC source.
After all connections have been made, push the power-switch in, to the on position.
After powering on, the router performs a self-test. Wait for a few seconds until the
test is finished, then the router will be ready to operate.
Caution 1:
If the router fails to power up, or it malfunctions, first verify that the
power supply is connected correctly. Then power it on again. If the
problem persists, contact our technical support engineers.
Caution 2:
Before servicing this equipment always disconnect all power cords
and telephone lines from the wall outlet.
Installation
8
Power Switch
Reset button
Advertisement
Table of Contents
