Chapter 2 Installation; Hardware Setup - Comtrend Corporation CT-5374 User Manual

Chapter 2 Installation

2.1 Hardware Setup

Follow the instructions below to complete the hardware setup.
BACK PANEL
The figure below shows the back panel of the device.
A/VDSL Port
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to the
power port. Attach the power adapter to a wall outlet or other AC source. Press the
power button to the ON position (IN). If the Power LED displays as expected then
the device is ready for setup (see section
Caution 1: If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely and then power it on again. If the
problem persists, contact technical support.
Caution 2: Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.
Reset Button
Restore the default parameters of the device by pressing the Reset button for 5 to
10 seconds. After the device has rebooted successfully, the front panel should
display as expected (see section
NOTE: If pressed down for more than 20 seconds, the CT-5374 will go into a
firmware update state (CFE boot mode). The firmware can then be
updated using an Internet browser pointed to the default IP address.
Ethernet (LAN) Ports
Ethernet (LAN) Ports
2.2 LED Indicators).
2.2 LED Indicators for details).
7
Power Button
Power Port
Reset Button