Table of Contents
Advertisement
2. Installation
2.1 Before Connecting to the Network
Before connecting the ES-7205/ES-7208 to the
network, please pay attention to the following
instructions:
2.2 Connecting to End Nodes
Use a standard Ethernet cable to connect the Switch to
end
nodes
automatically adjust to the characteristics (MDI-II/MDI-X,
speed, duplex) of the device to which it is connected
Do not put anything on top of the Switch. Place
on a hard, flat surface.
Power sockets and equipment should be within 5
feet of the Switch.
Check power supply to confirm a safe and secure
connection.
Make sure there is adequate space for proper
heat dissipation and adequate ventilation around
the Switch.
as
described
Switch connecting to an end node
below.
Switch
7
ports
will
Advertisement
Table of Contents
