Download  Print this page

Reversing The Door Swing; Maintenance Instructions - Whirlpool CSP2760TQ2 Installation Instructions Manual

Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)
Hide thumbs

Advertisement

REVERSINGTHE DOORSWING(OPTIONAL)
You can change your door swing from a right-side opening to a
left-side opening, if desired.
1.
2.
c
g
_\
Open dryer door. Remove bottom screws from cabinet side of
hinges (A). Loosen (do not remove) top screws from cabinet
side of hinges.
Lift door until top screws in cabinet are in large part of
hinge slot. Pull door forward off screws. Remove top
screws from cabinet.
Remove screws attaching hinges to door.
Remove screws from all sidess of door (5 screws). Grasp
sides of outer door and gently lift to separate it from inner
door (do not pry apart). Do not pull on door seat or plastic
door catch.
5.
6.
Reattach outer door panel to
inner door panel so handle
is on the side where hinges
were just removed.
Attach door hinges to dryer door so that the larger hole is
at the bottom of the hinge and the hinge pin is toward the
door front.
7. Remove the 4 screws that attach 2 plugs (B) on the handle
side. Attach plugs to opposite side using the same 4 screws.
8. Insert screws into bottom holes on left
side of cabinet. Tighten screws halfway.
_1
3.
Position door so large end of door hinge
4.
slot is over screws. Slide door up so
screws are in bottom of slots. Tighten
screws. Insert and tighten top
screws in hinges.
9. Close door and check that door strike aligns with door
catch (C).
MAINTENANCE INSTRUCTIONS
Maintenance
instructions:
[] Clean lint screen after each cycle.
[] Removing accumulated
lint:
• From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
• From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
[] Keep area around dryer clear and free from combustible
materials, gasoline and other flammable vapors and liquids.
[] Keep dryer area clear and free from items that would obstruct
the flow of combustion and ventilation air.
If dryer does not operate,
check the following:
[] Electrical supply is connected.
[] Circuit breaker is not tripped or house fuse is not blown.
[] Door is closed.
[] Controls are set in a running or "ON" position.
[] Cycle has been selected.
[] For gas dryers, check that gas supply shutoff valves are set
in open position.
If you need assistance:
The Commercial Laundry Support Center will answer any
questions about operating or maintaining your dryer not covered
in the Installation Instructions. Just dial 1-800 NO BELTS
(1-800-662-3587)
-- the call is toll free.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located in the dryer door well.
17

Advertisement

loading

  Related Manuals for Whirlpool CSP2760TQ2

This manual is also suitable for:

Csp2761tq4Csp2760tq3Csp2761tq3