Download  Print this page

Whirlpool CGM2745FQ Installation Instructions Manual

Commercial dryer gas or electric
Hide thumbs

Advertisement

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D'INSTALLATION
S
ÉCHEUSE À USAGE COMMERCIAL À GAZ OU ÉLECTRIQUE

TABLE OF CONTENTS

DRYER SAFETY ....................................................................... 2
TOOLS & PARTS ..................................................................... 5
DIMENSIONS/CLEARANCES ................................................ 6
DRYER VENTING REQUIREMENTS .................................... 13
GAS SUPPLY CONNECTION ................................................ 15
COIN BOX ............................................................................... 17
LEVELING .............................................................................. 23
COMPLETE INSTALLATION ................................................. 24
REVERSING DRYER DOOR SWING .................................... 25
MAINTENANCE INSTRUCTIONS ......................................... 27
IF YOU NEED ASSISTANCE ................................................. 27
WARRANTY ............................................................................ 28
W10867001A
W10867002A - SP
C
OMMERCIAL
D
G
RYER
AS OR
SÉCURITÉ DE LA SÉCHEUSE ........................................... 29
OUTILS ET PIÈCES ............................................................. 32
DIMENSIONS/DISTANCES DE DÉGAGEMENT ................ 33
EXIGENCES D'INSTALLATION POUR LA
SÉCHEUSE À GAZ ............................................................... 34
EXIGENCES D'INSTALLATION POUR
LA SÉCHEUSE ÉLECTRIQUE ........................................... 37
EXIGENCES CONCERNANT L'ÉVACUATION
DE LA SÉCHEUSE .............................................................. 39
RACCORDEMENT À LA CANALISATION DE GAZ ........... 41
INSTALLATION DES PIEDS DE NIVELLEMENT,
DE LA GLISSIÈRE À MONNAIE ET DE LA
CAISSE À MONNAIE ........................................................... 43
NIVELLEMENT ..................................................................... 44
ACHEVER L'INSTALLATION ................................................ 45
INVERSION DU SENS D'OUVERTURE DE LA PORTE ...... 46
INSTALLATION D'UNE CAME DE MINUTAGE
DE 30 OU 60 MINUTES ........................................................ 47
INSTRUCTIONS D'ENTRETIEN .......................................... 48
SI VOUS AVEZ BESOIN D'ASSISTANCE ............................ 48
GARANTIE ............................................................................. 49
E
LECTRIC
TABLE DES MATIÈRES
www.whirlpoolcommerciallaundry.com

Advertisement

loading

  Related Manuals for Whirlpool CGM2745FQ

  Summary of Contents for Whirlpool CGM2745FQ

  • Page 1: Table Of Contents

    INSTALLATION INSTRUCTIONS OMMERCIAL RYER AS OR LECTRIC INSTRUCTIONS D’INSTALLATION ÉCHEUSE À USAGE COMMERCIAL À GAZ OU ÉLECTRIQUE TABLE OF CONTENTS TABLE DES MATIÈRES DRYER SAFETY ............... 2 SÉCURITÉ DE LA SÉCHEUSE ........... 29 TOOLS & PARTS ..............5 OUTILS ET PIÈCES ............. 32 DIMENSIONS/CLEARANCES ..........
  • Page 2: Dryer Safety

    DRYER SAFETY It is recommended that the owner post, in a prominent location, instructions for the customer’s use in the event the customer smells gas. This information should be obtained from your gas supplier. Post the following warning in a prominent location.
  • Page 3 DRYER SAFETY IMPORTANT: When discarding or storing your old clothes dryer, remove the door.
  • Page 4: Important Safety Instructions

    DRYER SAFETY IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of re, electric shock, or injury to persons when using the dryer, follow basic precautions, including the following: Read all instructions before using the dryer. Clean dryer lint screen before or after each load. This dryer is intended only for drying clothes and textiles Do not use this dryer without the lint screen in place.
  • Page 5: Tools & Parts

    TOOLS & PARTS Tools Needed: 8" (203 mm) 8" (203 mm) or 10" (254 mm) Flat-Blade Screwdriver Phillips Screwdriver or 10" (254 mm) Adjustable Wrench Pipe Wrench that opens to 1" (25 mm) Torx T-20 Security 1" (25 mm) Hex-Head 5⁄16"...
  • Page 6: Dimensions/Clearances

    DIMENSIONS/CLEARANCES Dimensions Side View Back View " 27" (743 mm) (686 mm) 26" (660 mm) Electric " " (343 mm) (210 mm) 36" 41" (914 mm) (1042 mm) " (electric models) (273 mm) " " (38 mm) (953 mm) 4" dia (gas models) (102 mm) 35"...
  • Page 7: Gas Dryer Installation Requirements

    GAS DRYER INSTALLATION REQUIREMENTS Location Requirements Recessed Area and Closet Installation Instructions This dryer may be installed in a recessed area or closet. For recessed area and closet installations, minimum clearances can be found on the warning label on the rear of the dryer or in “Dimensions/Clearances.”...
  • Page 8: Electrical Requirements

    GAS DRYER INSTALLATION REQUIREMENTS Electrical Requirements Gas Dryer Grounding GROUNDING INSTRUCTIONS For a grounded, cord-connected dryer: ■ This dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This dryer is equipped with a cord having an equipment- grounding conductor and a grounding plug.
  • Page 9 GAS DRYER INSTALLATION REQUIREMENTS Gas Supply IMPORTANT: Observe all governing codes and ordinances. This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1/NFPA 54 or CAN/CSA B149. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park, Quincy, MA 02269...
  • Page 10: Electric Dryer Installation Requirements

    ELECTRIC DRYER INSTALLATION REQUIREMENTS Location Requirements The dryer must be exhausted outdoors. 48 in. (310 cm 3" (76 mm) Front Closet Front Closet View Door View door Your dryer can be installed in a basement, laundry room, or 3" recessed area. (76 mm) 24 in.
  • Page 11: Electrical Connection

    ELECTRIC DRYER INSTALLATION REQUIREMENTS Electrical Requirements – U.S.A. only (cont.) Electrical Connection Electric Dryer Power Supply Cord To properly install your dryer, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. This dryer is manufactured ready to install with a 3-wire electrical supply connection.
  • Page 12 ELECTRIC DRYER INSTALLATION REQUIREMENTS Direct Wire If connecting by direct wire: Power supply cable must match power supply (4-wire or 3-wire) and be: Flexible armored cable or nonmetallic sheathed copper cable (with ground wire), covered with exible metallic conduit. All current-carrying wires must be insulated. 10-gauge solid copper wire (do not use aluminum).
  • Page 13: Dryer Venting Requirements

    DRYER VENTING REQUIREMENTS Elbows: 45° elbows provide better air ow than 90° elbows. Better Good Clamps: Use clamps to seal all joints. Exhaust vent must not be connected or secured with screws WARNING: To reduce the risk of re, this dryer MUST BE or other fastening devices that extend into interior of duct EXHAUSTED OUTDOORS.
  • Page 14 DRYER VENTING REQUIREMENTS Vent Hoods 4" (102 mm) Diameter Exhaust Hoods Exhaust hood must be at least 12" (305 mm) from the ground or any object that may be in the path of the exhaust (such as owers, rocks, bushes, or snow). Box Hood Louvered Hood Angled Hood...
  • Page 15: Gas Supply Connection

    A clean-out cover should be located on the main vent for periodic cleaning of the vent system. NOTE: For more dryer venting information, please refer to Whirlpool document W10100920. GAS SUPPLY CONNECTION Make Gas Connection Open the toe panel. Use a putty knife to press on the toe panel lock located at the center top of the toe panel.
  • Page 16 GAS SUPPLY CONNECTION Type of Gas This dryer is equipped for use with natural gas. It is design- certi ed by CSA International for LP (propane and butane) gases with appropriate conversion. No attempt shall be made to convert dryer from gas speci ed on serial/rating plate for use with a different gas without consulting the serving gas supplier.
  • Page 17: Installing Leveling Legs, Coin Slide, And Coin Box

    INSTALLING LEVELING LEGS, COIN SLIDE, AND COIN BOX On some models: The meter case houses the factory-installed accumulator timer with actuating arm or service switch. The factory-installed timer is set to provide 45 minutes (4 pins) of drying time when activated by the coin slide. Timer cams for 30-minute (6 pins) and 60-minute (3 pins) drying times are included in the parts bag.
  • Page 18: Electric Dryer Electrical Connections

    ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY) Connection Options Power Cord Direct Wire 4-wire receptacle (NEMA Type 14-30R) 4-wire direct Go to "Power Supply Cord Connection" section. Go to "Direct Wire Connection" section. 3-wire receptacle (NEMA Type 10-30R) Go to "Power Supply Cord Connection" section. 3-wire direct Go to "Direct Wire Connection"...
  • Page 19 ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY) Connecting 4-Wire Connection: Power Supply Cord Connecting Power Cord Ground Wire IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire 3. Connect ground wire (green or bare) (E) of power supply cord connections.
  • Page 20: Direct Wire Connection

    ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY) Connecting 3-Wire Connection: Power Supply Cord (cont.) 3. Connect remaining wires under outer terminal block screws (F). Tighten screws. Finally, reinstall terminal block cover to dryer rear panel. Secure cover with hold-down screw. Now go to "Venting Requirements."...
  • Page 21 ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY) Connecting 4-Wire Connection: Direct Wire IMPORTANT: A 4-wire connection is required for mobile Connecting Direct Wire Ground homes and where local codes do not permit the use of 3-wire 3. Connect ground wire (green or bare wire) (E) of direct wire connections.
  • Page 22 ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY) Connecting 3-Wire Connection: Direct Wire Use where local codes permit connecting cabinet-ground 2. Place hooked end of neutral wire (white or center wire) conductor to neutral wire. (D) of direct wire cable under center terminal block screw (A), hook facing right.
  • Page 23: Leveling

    LEVELING 2. Grip dryer from top and rock back and forth, making sure all Leveling your dryer properly reduces excess noise and vibration. four legs are rmly on oor. Repeat, rocking dryer from side to side. If dryer rocks, go to Step 3 and adjust leveling legs. 1.
  • Page 24: Complete Installation

    COMPLETE INSTALLATION 6. Check dryer operation (on some models, some accumulated 1. Check the electrical requirements. Be sure that you have the time may be on the timer due to factory testing). Close dryer correct electrical supply and the recommended grounding door.
  • Page 25: Reversing Dryer Door Swing

    REVERSING DRYER DOOR SWING (OPTIONAL) You can change your door swing from a right-side opening to 7. Be certain to keep cardboard spacer centered between left-side opening, if desired. doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. Remove the Door Assembly 1.
  • Page 26: Changing To A 30- Or 60-Minute Timing Cam

    CHANGING TO A 30- OR 60-MINUTE TIMING CAM (on some models) 5. Place new cam (hub side down) over clock shaft. Line up at WARNING side of shaft with at side of cam hole. Check that drive lug is in place. Drive Lug Electrical Shock Hazard Disconnect power before making cam changes.
  • Page 27: Maintenance Instructions

    MAINTENANCE INSTRUCTIONS If dryer does not operate, check the following: Clean lint screen before and after each cycle. Removing accumulated lint: Electrical supply is connected. From inside the dryer cabinet: Circuit breaker is not tripped or house fuse is not blown. Lint should be removed every 2 years or more often, Door is closed.
  • Page 28: Warranty

    DISCLAIMER OF REPRESENTATIONS OUTSIDE OF WARRANTY Whirlpool makes no representations about the quality, durability, or need for service or repair of this major appliance other than the representations contained in this Warranty. If you want a longer or more comprehensive warranty than the limited warranty that comes with this major appliance, you should ask Whirlpool or your retailer about buying an extended warranty.