Table of Contents
Advertisement
Rev 2.4
9. Equipment Disposal
10. Local and National Electrical Codes
2.2.2 Mechanical Installation
The switch platform can be rack mounted and is designed for installation in a standard 19" rack.
The power side of the switch includes a hot-swap power supply module, a blank cover for an
optional second PSU for redundancy, a hot-swap fan tray, system LEDs, and management connec-
tion ports. There are two possible air flow directions. Be sure that the switch air flow direction is
compatible with your system and rack. The connector side of the switch has the QSFP ports.
The switch platform contains auto-sensing 90 - 264 VAC connections for all possible PSUs.
The installer should use a rack capable of supporting the mechanical and environmental character-
istics of a fully populated platform.
2.2.2.1 Minimum and Maximum Rack Depth for this Switch
This switch can be installed in any standard 19"racks with depths of 670mm to 900mm.
2.2.2.2 Installing the Switch in the Rack
Tools and Customer Supplied Parts
• Phillips Screwdrivers #1 and #2
• ESD Strap
• ESD mat
Parts included in the installation kit:
• 2 rails
• 2 rail slides
18
Mellanox Technologies
Disposal of this equipment should be in accordance to all national laws
and regulations.
This equipment should be installed in compliance with local and national
electrical codes.
The rack mounting holes conform to the EIA-310 standard for 19-inch racks.
Take precautions to guarantee proper ventilation in order to maintain good air-
flow at ambient temperature. Cable routing in particular should not impede the
air exhaust from the chassis.
• Grounding screw
• Grounding wire sufficient to reach a valid ground.
• 8 recessed flat head screws
• 4 caged nuts
Installation and Basic Operation
Advertisement
Table of Contents
