M3601Q 16+16 Port 40Gb/s InfiniBand Switch User Manual
8.
Equipment Disposal
Disposal of this equipment should be in accordance to all national laws and regulations.
9.
Local and National Electrical Codes
This equipment should be installed in compliance with local and national electrical
codes.
2.2
Mechanical Installation
These switches are hot pluggable. It is not necessary to power down the Dell Chassis to install a
new switch or to replace an old switch with a new one.
Channel 1 slots
A1 B1 C1
Note: M2401G blades are not allowed in the Fabric A slots.
2.2.1 Removing an Old Switch From the Chassis
1. Remove any locking cables or screws that secure the old switch into the chassis.
2. Disconnect all of the InfiniBand cables from the front of the switch to be removed.
Figure 4: Rear View of the Dell PowerEdge M1000e Chassis
Channel 2 slots
C2 B2 A2
Mellanox Technologies
Latch Release Buttons
Locking Arms
11
Rev 1.7