Table of Contents
Advertisement
InfiniScale® IV 36-Port QSFP InfiniBand Switch User Manual
9.
Equipment Disposal
10. Local and National Electrical Codes
11. Battery Replacement
2.2.2 Mechanical Installation
The switch platform can be rack mounted and is designed for installation in a standard 19" rack. The power
side of the switch includes a hot-swap power supply module, a blank cover for an optional second PSU for
redundancy, a hot-swap fan tray, system LEDs, and management connection ports. The hot-swap fan module
provides front to back air flow. The rear of the switch has the QSFP ports.
The switch platform contains auto-sensing 90 - 264 VAC connections for all possible PSUs.
The installer should use a rack capable of supporting the mechanical and environmental characteristics of a
fully populated platform.
2.2.2.1 Installing the Switch in the Rack
Tools needed:
Phillips Screwdriver
ESD Strap
ESD mat
Disposal of this equipment should be in accordance to all national laws and reg-
ulations.
This equipment should be installed in compliance with local and national elec-
trical codes.
There is a risk of explosion should the battery be replaced with a battery of an incorrect
type.
Dispose of used batteries according to the instructions.
The rack mounting holes conform to the EIA-310 standard for 19-inch racks. Take pre-
cautions to guarantee proper ventilation for air intake at the power side of the chassis
and exhaust at the connector side in order to maintain good airflow at ambient temper-
ature. Cable routing in particular should not impede the air exhaust from the chassis.
Mellanox Technologies
13
Rev 2.0.0
Advertisement
Table of Contents
