Table of Contents
Advertisement
Mounting the Camera
(VN-H657WPU)
1 Mount the fall prevention wire.
Mount the fall prevention wire of the camera
0
to the fall prevention wire anchor bolt that
was installed earlier.
Secure the fall prevention wire tightly with a
0
nut and washer.
2 Run the cables (from the wall) through
the cable connection hole.
3 Mount the camera to the wall.
Mount the camera to the camera anchor
0
bolts that were installed earlier.
Secure the camera tightly with a nut and
0
washer.
Fall prevention
wire
.
Note :
This product weighs approximately 5.6 kg.
0
Mount the camera while paying careful attention
to prevent it from falling.
For your safety, hold the arm section during
0
installation.
After installing, paint the nuts and washers to
0
prevent corrosion.
4 Connect the power cable.
To supply power from an AC 24 V power
0
supply, connect a power cable.
To supply power via PoE plus, you do not
0
need to connect a power cable. Go to the
next step.
(A P30 [Connect the LAN cable.] )
After connecting the power cable, wind the
0
waterproof tape (adhesive).
After connecting, push the power cable into
0
the arm of the camera.
Wind the waterproof tape (adhesive)
Power cord for connecting to AC 24 V
.
(Reference value)
Conductor Diameter
Φ1.0 and above
Φ1.6 and above
Φ2.0 and above
Arm
Φ2.6 and above
Nut
Memo :
Washer
The default IP address setting is 192.168.0.2.
0
Note :
For safety reasons, turn on the power only after
0
ensuring that all the connections are in place.
If power is supplied from both power cable and
0
LAN cable, priority will be given to the power
supply from the power cable.
If multiple cameras are turned on
0
simultaneously in the same LAN environment,
access attempts may fail due to IP address
duplication. Set up an IP address by either using
the JVC-VN-IP SettingTool (included on the
supplied CD-ROM) or turning the power supply
of each camera on separately to avoid
duplication.
Maximum connection
(mm)
20
60
100
180
Mounting the Camera (VN-H657WPU)
Solder welding or
crimping
Insulating tape
To Power Supply
distance (m)
29
Advertisement
Table of Contents
