Mounting The Camera To The Ceiling Mount Bracket; Attaching Label To The Camera - JVC KY-PZ400 Series Instructions Manual

Mounting the Camera to
the Ceiling Mount Bracket
Be sure to put on protective glasses to protect
0
your eyes from falling objects when mounting
the camera.
Be sure to place the base of the camera
0
horizontally. The camera will not operate
properly if it is slanted.
Memo :
The ceiling mount bracket is not necessary
0
when the camera is installed on a desktop or
attached to a tripod.
If necessary, make a hole (Φ40 mm) to route the
0
connection cable and fall prevention wire
(ceiling) into the ceiling.
Caution :
The fall prevention wire (for ceiling) is not
0
supplied. Make use of the wire while taking note
of its length, strength, pull and material
(insulation).
Attach the fall prevention wire (ceiling) to a place
0
with sufficient strength (ceiling slab, etc.).
Take note of the length, strength, pull and
0
material (insulation) of the fall prevention wire
(for ceiling) and use one with a wire strength of
150 N (15 kg) or more.
The inner diameter of the ring section of the fall
0
prevention wire (ceiling) mounted on the camera
should be above Φ3 mm but below Φ4 mm, the
outer diameter should be Φ9 mm and below, and
the thickness 2 mm and below.
The camera does not come with mounting
0
screws for attaching it to the ceiling. Make
appropriate use of the M5 expansion screws
(x4) according to the thickness of the ceiling.
1 Place the ceiling mounting bracket (ceiling
side) against the ceiling and mark the
mounting position on the ceiling
Memo :
Take note of the front direction of the camera
0
when placing the marks.
2 Drill holes into the ceiling at the marked
positions
Memo :
Insert a straw or toothpick into the mounting
0
holes to determine the depth and required
length of the screws.
3 Place the ceiling mounting bracket (ceiling
side) against the ceiling again at the
marked position
4 Fasten the mounting bracket using the M5
expansion screws (sold separately)
Memo :
Check that the screws are tighten securely when
0
mounting is completed.
.
Attaching Label to the
Camera
.
Before installing the camera to the ceiling, attach
the JVC logo label as illustrated in the diagram.
1 Peel off the label backing
2 Turn the label upside down
3 Align the center position of "V" of the JVC
logo on the camera with that on the label,
followed by attaching the label
Memo :
If there is dust or dirt on the surface, remove
0
accordingly before attaching the label.
Make sure that the JVC logo label is not tilted
0
when attaching.

Mounting the Camera to the Ceiling Mount Bracket

21