Table of Contents
Advertisement
Installation and Connection
Preparations (VN-H657WPU)
Be sure to put on protective glasses to protect your
eyes from falling objects when mounting the
camera.
Setting Up the Wall
1 Make a hole in the wall.
Make a hole (Φ45 mm) for the connecting
0
cables to pass through.
Note :
Check the strength of the wall. A less firm wall
0
may cause the unit to fall.
2 Install the anchor bolts for mounting
the camera.
Install 4 anchor bolts (M8 ´ 35 mm and
0
above) to mount the camera.
3 Install the anchor bolt for mounting the
fall prevention wire.
Install the anchor bolt to mount the fall
0
prevention wire 30 mm below the center of
the upper two anchor bolts that are used to
mount the camera.
152
126
63
Anchor bolt to
mount the fall
prevention wire
.
4 Pull the cables from the hole in the
.
Setting Up the Camera
1 Remove the dome cover.
.
2 Remove the lens cap and tape used
Anchor bolts to
mount the camera
.
Memo :
0
Installation and Connection Preparations (VN-H657WPU)
wall.
Pull the power cable, LAN cable and alarm
0
signal cable from the wall.
Loosen the screws (x4) and remove the
0
dome cover from the camera.
Dome cover
during transporting.
Tape
Lens cap
When installing the heater at an unrequired
location, turn off the ON/OFF switch of the
heater.
LAN cable
Power cable
Alarm signal
cable
Heater ON/OFF
switch
OFF
27
Advertisement
Table of Contents
