Table of Contents
Advertisement
4-22 System Configuration
Option
BMC Firmware Revision
SDR Revision
PIA Revision
Module#0 BMC MAC Address*
Module#1 BMC MAC Address*
* MAC address information is shown only when the N8815-001/001A ft Remote Management Card
is installed. (Installed in standard for 320Fb-M and 320Fb-MR models)
Console Redirection
Select "Console Redirection" on the System Hardware menu and press Enter to display the
following screen.
See the table below for setup options on the screen.
Option
BIOS Redirection
Port
Baud Rate*
Parameter
Parameter
[Disabled]
Enabled
9600
[19.2K]
38.4K
57.6K
115.2K
Description
Displays the BMC information.
Displays the revision of SDR (sensor
device information).
Displays the PIA (plat form information)
revision.
Displays the BMC MAC address of
CPU/IO module#0.
Displays the BMC MAC address of
CPU/IO module#1.
Description
Enable or disable Console Redirection. By enabling
this option, you can remotely control behavior during
POST.
Select a port rate used for the interface with a
hardware console to be connected.
[
]: Factory-set
Advertisement
Table of Contents
Troubleshooting
