NEC N8800-096F User Manual page 297

5-72 Installing and Using Utilities
modules automatically. In that case, the BIOS update status dialog is displayed, so check its
information. If the automatic update completes, it is not required to take the following steps.
If the automatic update of BIOS is not set by GeminiEngine Monitor Tool, click the [Down]
button of the module you want to stop and continue to the following operation. For the
details on GeminiEngine Monitor Tool, see "GeminiEngine Monitor Tool" on page 5-86 of
this guide.
8.
Click [Diagnostics] in [Diagnostics Information] of the other stopped PCI module.
9.
Start the other inactive module.
Starting the module causes the firmware to be updated automatically. However, if the [Enable
automatic firmware update] property is disabled, the module is not started. In such a case,
perform the following operations before starting the module:
(1) Click the [Firmware...] button in the Server Maintenance Utility screen for the target
component.
(2) On the [Firmware Update] dialog box, select
[Copy online BIOS image to offline.] as a
method for updating and click [Execute].
(3) Check the result of the update in the event log.
CHECK:
When stopping IO module, check that the status of Ethernet is "Duplex" on Server Maintenance
Utility. Do not stop the IO module especially when LAN is connected only to the IO module on
that side.