Table of Contents
Advertisement
Move the cursor to the test that detected the error, and press the Enter key. Record the
error message that has been output to the Detail Information screen and contact your sales
agent.
7.
Follow the guideline shown at the bottom of the screen, and press the Esc key.
The [Enduser Menu] below is displayed.
<Test Result>
Shows the diagnostics completion screen of the above diagnostics.
<Device List>
Shows a list of connected devices.
<Log Info>
Shows the log information of the diagnostics. It can be saved on a floppy disk. To save it
on a floppy disk, insert a formatted floppy disk to the floppy disk drive, and select
<Save(F)>.
<Option>
Changes the output destination of a log.
<Reboot>
Reboots the system.
8.
Select <Reboot> in the [Enduser Menu] above.
The server restarts and the system is started from the NEC EXPRESSBUILDER.
9.
Exit the NEC EXPRESSBUILDER, and remove the CD-ROM from the CD-ROM drive.
10.
Power off the server and unplug the power cord from the receptacle.
11.
Reconnect all the LAN cables that have been disconnected in Step 2 to the server.
12.
Plug the power cord.
This completes the system diagnostics.
Maintenance 6-9
Advertisement
Table of Contents
Troubleshooting
