Table of Contents
Advertisement
Hardware
1.8.1
Enable/Disable Component
Enable/Disable Component is displayed by selecting "Fault Information" and clicking
"Enable/Disable" of the menu on the left side of the screen.
Hardware unit status (Enable/Disable) can be checked and hardware unit can be set manually in
Enable/Disable Component.
(1)
Display/set Enable/Disable status.
Contents to be displayed are as follows.
Setting
Name
(2)
Clicking "Submit" enables to set the information of (1).
(3)
Clicking "Cancel" enables to move to Fault Information screen.
(2)
: Enable/Disable status
: Disable sensor name
IMPORTANT:
• When non-redundant hardware unit is set to Disable, server
cannot be booted.
• When hardware unit which was previously disabled is set to
Enable, the phenomenon may reoccur to the unit although it may
temporarily recover.
(3)
404
(1)
Advertisement
Table of Contents
Troubleshooting
