Table of Contents
Advertisement
Hardware
WebBIOS Home
WebBIOS Home is the menu to start the operation. Shown below is [Adapter Selection] screen
that appears first on WebBIOS. Check if "Bus No 5" is selected as a controller to operate
WebBIOS, then select [Start], and press Enter.
When the adapter is selected on [Adapter Selection], the following WebBIOS Home Menu
appears.
Physical Drives in the upper right box show the Physical Drives (PD) that are configured.
Virtual Drives in the lower right box show the Virtual DISKs (VD) that are configured.
IMPORTANT:
"X:X:X" shown in Physical Drives box represents
Connector number:Enclosure number:Slot number. With this server,
the Connector number is not supported, thus, it is always indicated
as "()". The Enclosure number is always "1". The Slot number is the
number on the drive tray of the server.
334
Advertisement
Table of Contents
Troubleshooting
