LifeSpan Equalizer User Manual page 22

6. Heart rate not displayed
7. Operation stops
automatically and E1 is
displayed.
8. The treadmill operates
normally with no load but
halts midway.
9. The display fails to work
normally or cannot display at
all, and the keys don't work.
Power Problems
1. Check fuses (They are located on the controller under the motor cover next to the
on/off switch.
2. Check power outlet (Plug something else into the power outlet to ensure that the
power outlet is working correctly).
3. Check Power Cable (You may need to take it to an electrician).
Display Errors.
1. E01: speed failure
Possible reason: the speed signal has not been switched to the driver yet.
Elimination method: check the speed signal.
2. E02: overcurrent protection
Possible reason: A electric motor is overloaded.
Elimination method: Shut down A electric motor first and then start is again. If the
failure has not been eliminated by then yet, customer may get the electric motor
repaired.
3. E03: explosion-proofing protection
Possible reason: the electric motor wire is pulled off when the electromotor runs at a
high speed.
1. Transmitter not making
good contact with skin.
2. Electromagnetic
interference.
The self-maintenance
function of system works
suddenly.
The strap becomes loose.
The electronic meter is
influenced by an external
factor.
LIFESPAN EQUALIZER
1. Moisten skin contact area on the
transmitter strap, or turn
transmitter strap upside down.
2. Turn off any television,
microwave, or computer within 6
feet of treadmill.
1．Restart the treadmill after
pressing 'STOP'.
2．Restart the treadmill after the
power supply has been
disconnected for 5min.
3．Replace the sensor.
Adjust the strap following the
specification.
Disconnect the power supply and
switch off switches, and restart the
treadmill 5min later.
Page 21