Automatic Bypassing Of Open Sensors; Automatic Restoral Of Bypassed Sensors; Disabling Quick Arming - Linear DEFIANT SSD Owner's Manual

AUTOMATIC BYPASSING OF OPEN SENSORS

PROGRAMMING STEP #60
PROGRAM
0 FOR AUTO BYPASS OFF
1 FOR AUTO BYPASS ON
STORE PROGRAM

AUTOMATIC RESTORAL OF BYPASSED SENSORS

PROGRAMMING STEP #61
PROGRAM
0 FOR AUTO RESTORAL OFF
1 FOR AUTO RESTORAL ON
STORE PROGRAM

DISABLING QUICK ARMING

PROGRAMMING STEP #62
PROGRAM
0 FOR QUICK ARMING OFF
1 FOR QUICK ARMING ON
STORE PROGRAM
28
The factory setting causes the Console to
automatically bypass any open sensors when
the system is armed.
Alternately, the Console can be programmed
to not arm on the first attempt if there are
any open sensors.
If automatic bypassing is turned off, and
arming is attempted with open sensors, the
Console will sound five two-tone beeps and
will not arm.
Arming to the same mode again within five
seconds will bypass any open sensors and
arm the Console.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
If a sensor is open when the system is
armed, the Console will bypass it.
The factory setting causes the Console to
automatically restore (remove the bypass
from) any bypassed sensor when the sensor
closes. After it's restored, the sensor is ready to
cause an alarm the next time it is opened.
Alternately, the Console can be programmed
to not automatically restore sensors that close.
Bypassed sensors will remain bypassed until
the system is disarmed.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
The factory setting allows the Console to be
armed by holding down the mode keys for
two seconds.
Alternately, the Console can be programmed
to not allow quick arming.
If quick arming is disabled, your secret code
must be entered before pressing the mode
buttons.
Exit Learn Mode when all programming
changes are complete.