Removing Sensors From The System; Making A Sensor A 24-Hour Door Chime - Linear DEFIANT SSD Owner's Manual

REMOVING SENSORS FROM THE SYSTEM

START IN OFF
YOUR
SECRET
CODE
1 GONG &
5 BEEPS
SENSOR
NUMBER
TO REMOVE
1 BING
TEST
DONE

MAKING A SENSOR A 24-HOUR DOOR CHIME

START IN OFF
YOUR
SECRET
CODE
1 GONG &
5 BEEPS
SENSOR
NUMBER
FOR CHIME
HOME
T U
8
V
1 BING
AWAY
DONE
24
If a previously learned sensor isn't going to
be used with the system anymore, it should
be removed from the Console's memory.
Start with the Console in Off Mode.
Enter your secret code and press the
[LEARN] button.
A "gong" and five "beeps" will sound.
The sensor status indicators will light for
each sensor programmed into the Console.
Enter the sensor number (from 01-16) that
you want to remove (you must enter two
digits, example: 5 = 05)
The sensor indicator light will flash for the
sensor number selected.
Press the [TEST] button.
A single "bing" tone will sound when the
sensor has been removed and the sensor
status indicator will turn off.
Exit Learn Mode by holding the [OFF] button
for three seconds.
Sensors can be programmed to cause the
Console to chime any time they're activated.
Chime-only sensors will not be able to
trigger the alarm in any Console mode.
The sensor must have already been learned
by the Console (see "Adding sensors to the
System" for details).
Start with the Console in Off Mode.
Enter your secret code and press the
[LEARN] button.
A "gong" and five "beeps" will sound.
The sensor status indicators will light for
each sensor programmed into the Console.
Enter the sensor number from 01-16 (you
must enter two digits, example: 5 = 05)
The sensor indicator light will flash for the
sensor number selected.
Press [HOME], 8, then [AWAY]. A "bing"
tone will sound.
Exit Learn Mode by holding the [OFF] button
for three seconds.