Test Pre-Programmed Sensors; Sensor Response Switch; Example Sensor Installation - Linear SSD8 Installation Instructions & Owner's Manual

TEST PRE-PROGRAMMED SENSORS

1
REMOVE
BATTERY
STRIP
3
PULL
MAGNET
AWAY

SENSOR RESPONSE SWITCH

DELAYED SETTING WILL ALLOW A
45 SECOND DELAY FOR EXIT AND ENTRY
IN THE HOME AND AWAY MODES
INSTANT SETTING WILL CAUSE INSTANT
ALARMS IN THE HOME AND AWAY MODES
CHIME MODE "DING-DONGS" ARE ALWAYS
INSTANT REGARDLESS OF SWITCH SETTING

EXAMPLE SENSOR INSTALLATION

SENSOR
ON FRAME
MAGNET
ON WINDOW
WHEN THE DOOR OR WINDOW
IS CLOSED, THE MAGNET MUST
BE NEXT TO THE SENSOR
4
2
PLACE
MAGNET
NEXT TO
SENSOR
ON THIS
SIDE
4
PUT
MAGNET
BACK
SET THE SENSOR
RESPONSE SWITCH ON
EACH DOOR/WINDOW
SENSOR TO INSTANT
OR DELAYED
SENSOR
MAGNET
ON FRAME
ON DOOR
Place Console in Chime Mode by pressing [CHIME]
for two seconds.
1. Remove the battery protection strip from each
sensor.
2. Position the magnets next to the two door/window
sensors as shown.
3. Move the magnet away from one of the sensors.
The Console should "ding-dong" and sensor status
indicator #1 or #2 should light.
4. Reposition the magnet next to the sensor. The
sensor status indicator on the Console should go out.
Note which sensor location number the sensor is
pre-programmed into.
Perform the same test with the other sensor, noting
its sensor number.
Each door/window sensor has an
INSTANT/DELAYED switch located on its bottom.
The switch controls how the Console in the Home or
Away Mode will respond to the sensor.
Sensors set to DELAYED will have a 45 second exit
and entry delay. (Use this position for the entry/exit
door.)
Sensors set to INSTANT will trigger the Console
immediately. (Use this position for windows and
non-entry doors.)
Sensors mount on the door or window frame.
Magnets mount on the door or on the moving part of
the window.
Sensors can be mounted with the double-stick tape
supplied, or with the screws supplied (screws are
recommended in permanent installations).