Preparing The Console; Labeling Your Sensors - Linear DEFIANT SSD Owner's Manual

9. PREPARING THE CONSOLE

LABELING YOUR SENSORS

USE LABELS PROVIDED
TO IDENTIFY SENSORS
14
The two sensors provided are
pre-programmed as sensors 01 and 02.
A label sheet with sensor location names is
provided with the Console.
Open one protected door/window.
Choose a label that describes the sensor
location, or write the location on a blank
label, and stick it in the area to the right of
the sensor light.
Close the protected opening that you just
labeled.
Repeat for each protected opening.
Press the [AUTO] key on the wireless keypad.
The sensor 16 status light should go on for a
few seconds.
Stick the KEYPAD label in the spot for
sensor 16.