Bi-Weekly System Testing; Test Mode; Sensor Low Batteries - Linear DEFIANT SSD Owner's Manual

14. BI-WEEKLY SYSTEM TESTING

TEST MODE

START HERE
(OPTIONAL)
YOUR
SECRET
CODE
1 GONG &
TEST
4 BEEPS
DONE

SENSOR LOW BATTERIES

WHEN CONSOLE INDICATES A SENSOR
LOW BATTERY, OPEN SENSOR CASE AND
GENTLY LIFT UP END OF BATTERY CLAMP,
SLIDE BATTERIES OUT
NOTE: USE OF EXCESSIVE FORCE ON
BATTERY CLAMP WILL RESULT IN DAMAGE
LIFT
REMOVE BATTERIES
IF NECESSARY
FROM THIS END
PUSH IN SLOT TO REMOVE
SENSOR FROM MOUNTING PLATE
When the TEST SENSORS light comes on,
you should test each sensor in the system.
The Console must be in Off Mode before
going to Test Mode.
Switch the Console into Test Mode by
entering your secret code and pressing
[TEST].
When the system is switched to the Test
Mode, the Console will sound a "Gong" and
four "Beeps".
Placing the system in Test Mode will turn the
TEST SENSORS light off.
Holding down the [TEST] button will light all
of the Console's indicators.
The sensor status lights will flash for each
sensor programmed into the Console.
Go to each sensor and press its test button
or open and close the protected opening.
To test the wireless keypad, press the
[AUTO] key.
As each sensor is tested, the sensor status
light for the sensor will stop flashing and
return to showing the current status of the
sensor.
The Console will make a "bing" sound as
each sensor is tested.
Continue testing until there are no flashing
status lights.
NOTE: If the Console is left unattended in
Test Mode, it will automatically switch back
to Off Mode after 3 minutes.
When a sensor's status light on the Console
blinks, the sensor has a low battery.
NOTE: Don't confuse a blinking status light
with a flashing status light (flashing light is
+
faster and indicates alarm memory).
-
+
-
Refer to the figure when replacing
INSTALL TWO
DURACELL
door/window sensor batteries.
TYPE DL 2032
BATTERIES (+)
SIDE UP
21