8. MOUNT SENSORS
MAGNET
ON WINDOW
SET SENSOR SWITCH
SLIDE SWITCH
TO THE INSTANT
OR DELAYED
POSITION
APPLY DOUBLE-STICK TAPE
APPLY
DOUBLE-STICK
TAPE TO BACK
OF SENSOR
AND MAGNET
MOUNTING
PLATES
12
SENSOR
ON FRAME
SENSOR
ON FRAME
A switch on the bottom of the door/window
sensor selects instant or delayed response.
If the sensor is going to be used on your
primary entry/exit door make sure that the
switch is in the DELAYED position.
If the sensor is going to be used on a
window or a door that is not going to be
used to enter and exit the premises, slide the
sensor switch to INSTANT.
Apply double-stick tape (supplied) to back of
sensors and magnets.
Screws are also provided to mount sensors
and magnets.
Screws are preferred over the double-stick
tape in permanent installations.
NOTE: Double-stick tape is not allowed in
UL installations.
MAGNET
ON DOOR