Advanced Programming; Learn Mode; Entry Delay Time; Exit Delay Time - Linear DEFIANT SSD Owner's Manual

17. ADVANCED PROGRAMMING

LEARN MODE

START IN OFF
YOUR
SECRET
CODE
1 GONG &
5 BEEPS
LEARN MODE

ENTRY DELAY TIME

PROGRAMMING STEP #20
PROGRAM
TIME IN SECONDS (1-255)
STORE PROGRAM

EXIT DELAY TIME

PROGRAMMING STEP #21
PROGRAM
TIME IN SECONDS (1-255)
STORE PROGRAM
26
To perform any of the advanced
programming steps, the Console must be in
the Learn Mode.
Start with the Console in Off Mode (Learn
Mode cannot be reached from any other
mode).
Enter Learn Mode by entering your secret
code and pressing the [LEARN] button.
NOTE: Only the master secret code can be
used to put the Console into the Learn
Mode. The restricted secret code cannot
access Learn Mode.
A "gong" and five "beeps" will sound,
signaling that the Console is in Learn Mode.
Hold the [OFF] key for three seconds when
you want to exit Learn Mode.
NOTE: If the Console is left unattended in
Learn Mode, it will automatically switch back
to Off Mode after three minutes.
The factory-set Entry Delay time is 45
seconds.
The Entry Delay time can be adjusted from
one to 255 seconds.
NOTE: Don't make your Entry Delay too
short. You may not have enough time to
disarm the system before an alarm.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
The factory-set Exit Delay time is 30 seconds.
The Exit Delay time can be adjusted from
one to 255 seconds.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.