Home Automation Output Flashes During And After Alarm; Remote Control Arm/Disarm Chirp; Home Automation Activation Tone - Linear DEFIANT SSD Owner's Manual

HOME AUTOMATION OUTPUT FLASHES DURING AND AFTER ALARM

PROGRAMMING STEP #72
PROGRAM
0 FOR STANDARD TRIGGER
1 FOR FLASHING ON & AFTER ALARM
STORE PROGRAM

REMOTE CONTROL ARM/DISARM CHIRP

PROGRAMMING STEP #73
PROGRAM
0 FOR CHIRPS OFF
1 FOR CHIRPS ON
STORE PROGRAM

HOME AUTOMATION ACTIVATION TONE

PROGRAMMING STEP #74
PROGRAM
0 FOR BING TONE OFF
1 FOR BING TONE ON
STORE PROGRAM
The factory setting causes the Console's
Home Automation Output to activate when
pressing the [AUTO] key, or when it's
triggered with a two-button remote control.
In addition, the Console can be
programmed to flash the Home Automation
Output during and after any alarms.
The output will continue to flash until the
flashing status lights are cleared.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
When arming with the portable remote
control, the factory setting causes the
Console to "chirp" once when armed, twice
when disarmed, and three times when
arming with sensors bypassed.
Alternately, these chirps can be silenced.
If these chirps are silenced, it is
recommended to program the Home
Automation Output to be active when the
system is armed, so a light can be triggered
displaying the arming status of the Console.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
The factory setting causes the Console to
sound a "bing" when the Home Automation
Output is activated by pressing the [AUTO]
key, or when it's triggered with a two-button
remote control.
Alternately, this sound can be silenced.
The Console must be in Learn Mode to
make this change.
Exit Learn Mode when all programming
changes are complete.
31