Using The System When Leaving; Away Mode - Linear DEFIANT SSD Owner's Manual

12. USING THE SYSTEM WHEN LEAVING

AWAY MODE

START HERE
(OPTIONAL)
YOUR
SECRET
CODE
1 GONG &
AWAY
3 BEEPS
DONE
START HERE
HOLD
DOWN
AWAY
1 GONG &
3 BEEPS
DONE
EXIT DELAY (For Leaving the Premises)
30
SECONDS
18
Use this mode when no one will be staying
home.
Away Mode causes an instant alarm when
any perimeter sensor switched to INSTANT
is triggered.
Away Mode causes a delayed alarm when
any perimeter sensor switched to DELAYED
is triggered.
Away Mode causes an instant alarm when
any interior sensors (optional interior motion
detectors) are triggered. The interior sensors
will be delayed if a perimeter delayed sensor
is triggered first.
Alarm siren stops automatically after five
minutes and the system will remain armed
This can occur an unlimited number of times.
Arm to Away Mode by entering your secret
code, and pressing [AWAY].
You can "Quick Arm" to Away Mode from
Home, Chime or Off Mode by holding down
the [AWAY] key for two seconds. (Quick
arming can be disabled; see the Advanced
Programming Section of this manual.)
When the system is armed to the Away
Mode, the Console will sound a "Gong" and
three "Beeps".
During the 30 second Exit Delay, the
Console will sound "beeps" and the AWAY
light will blink.
The Exit Delay gives you 30 seconds to leave
the premises through a delayed perimeter
door without triggering an alarm.
When the Exit Delay is over, the Console will
sound one "gong" to warn you that the
system is fully armed.
NOTE: The Exit Delay time can be changed;
see the Advanced Programming Section of
this manual.