Table of Contents
Advertisement
WARMING UP
INCOMPATIBLE NETWORK
OPTION INSTALLED (on the
startup page)
n
CALL FOR SERVICE
A mechanical error has occurred and a service call is required.
Before calling for service, make a note of the full message in the
message window. See appendix A, "QMS Customer Support," for
information on how to contact QMS. When a CALL FOR SER-
VICE x appears, the printer stops until the required service is
complete.
Note: A service message sometimes occurs as a result of an
»
unusual combination of events, not because of an actual problem.
When the printer stops and a service message displays in the
message window, turn the printer off, wait 5 minutes, then turn it
back on. This often clears the service message indicator and
printer operation resumes. Always try this before making a
service call.
n
100K CHECKUP
Approximately 100,000 pages have been printed. It's time for
periodic maintenance and parts replacement to protect your
printer and maintain print quality.
n
REPLACE FUSER
It's time to replace the fuser to ensure print quality and reduce
wear on your printer.
The 100K CHECKUP and the REPLACE FUSER messages can be
cleared through the Clear Warning option in the Administration/
Engine menu. Then, you can continue to use the printer. (See "Clear-
The printer is warming up; the fuser is
at a low temperature. Wait until the
printer has warmed up before you print.
Except for the LocalTalk interface, the
QMS magicolor CX printer is
compatible only with magicolor CX
interfaces. If a non- magicolor CX
interface is installed, this error
message appears on the start-up page.
Advertisement
Table of Contents
