Page 3
This kit includes all the hardware necessary for converting a QMS magicolor WX Print System into a QMS magicolor CX Print System. In addition to this guide, your upgrade kit contains the following items. Make sure that you have all of these items before proceeding with the installation.
Page 4
Converting your QMS magicolor WX to a QMS magicolor CX Print System involves two steps: Removing the magicolor WX controller board and installing the magicolor CX controller board. » Note: You’ll need a flat-head screwdriver to complete this procedure. Applying the appropriate identification labels.
Page 5
5. Remove any SIMMs you purchased separately from their packaging and install them on the magicolor CX controller board. Refer to chapter 2, “Printer Options,” of your QMS magicolor CX Reference manual for SIMM installation instructions. Carefully remove any RAM SIMMs from the magicolor WX controller board, and, if necessary, install them on the magi- color CX controller board.
Page 6
If you purchased any other options, such as an internal hard disk or an Intellifont SIMM, install them now. Refer to chapter 2, “Printer Options,” of your QMS magicolor CX Reference manual for instructions. Reinsert the controller board, making sure it’s properly seated in its con- nectors.
Page 7
The following diagrams show where the new identification labels should be installed on the printer.
Page 8
QMS. To verify the conversion, print a start-up page. The print system name QMS magicolor CX on the printer start-up page indicates that the printer has successfully been converted from a QMS magicolor WX to a QMS magicolor CX Print System.