Table of Contents
Advertisement
6
Pour the fuser oil into
an appropriate waste
container.
(For example, you could
use an old jar.) Dispose
of the oil following local
safety laws and regula-
tions.
7
Using a clean, dry, lint-free cloth or some cotton swabs, wipe
any remaining oil out of the tray.
8
Return the fuser unit to its slot, and stuff a clean, wadded
paper towel into the place normally occupied by the oil bottle
to act as a cushion and to absorb any residual oil during the
move.
The pressure-release pieces protect the fuser roller from damage
during a move by helping to relieve the tension on the roller. They
must be installed for the move and removed again before printing.
1
With the printer's top cover off and paper exit-unit still open,
pull back the two latches (one on each side) of the separator
Advertisement
Table of Contents
