Table of Contents
Advertisement
12 Reprint the Color Balance Adjustment Page.
13 Check the Target square again to see if the center swatch is
gray or neutral.
a
If it is not then repeat steps 10 through 12 for the next color.
b
If it is, then stop here.
When the printer needs operator assistance, the message window
displays one of the following messages:
Status message
x ACTIVE JOBS
ADJUST xxxxx BIN
BACK PANEL OPEN
BELT CARTRIDGE
MIS-INSTALLED
CANCELLING JOB
Explanation
The printer is on line. x identifies the
number of jobs in process.
A media cassette is either not installed
or installed incorrectly. The xxxxx
indicates the cassette in question.
Either install or reinstall the indicated
cassette.
The back cover over the transfer unit is
not fully closed. Close the back cover.
The OPC belt cartridge is either not
installed or incorrectly installed. Either
install a cartridge if one is not present
or reinstall the current one correctly.
(See chapter 3, "Maintenance," for
information on replacing the OPC belt
cartridge.)
The Cancel key has been used to
cancel the current job. This message is
displayed until the job is cancelled.
Advertisement
Table of Contents
