Normal Operation; General; Temperature Settings-With Remote Controller - Takagi 110 Indoor (T-KJr2-IN) Installation Manual And Owner's Manual

NORMAL OPERATION

• Hot water temperature above 125 °F (52 °C) can cause
severe burns instantly or death from scalding.
• The outlet hot water temperature of the water heater is
factory set at 122 °F (50 °C).
WARNING
• Feel the water temperature before bathing or showering.
NOTICE
• Flow rate to activate the water heater: 0.5 gallon per minute at the default set
• Flow rate to keep the water heater running: 0.4 gallon per minute.
1. Open a hot water tap. 2. Mix cold water with the hot to get
a) 110 (T-KJr2) and 310 (T-K4) models: 9007666005 (TK-RE02)
<Set temperature>
1. Turn on the 120 VAC power supply to the water heater.
2. Press the "OPERATION" button on the remote in order
to turn the remote controller on. It shows the set
temperature on its display as shown to the right.
3. Press the "HOT" button or the "COLD" button to set the
temperature setting of the unit.
4. You can set the temperature from 99 °F (38 °C) to 122
°F (50 °C).
Increasing temperature from 122 °F (50 °C) to 140 °F (60 °C)
Press the "HOT" button to set 122 °F (50 °C).
•
Press and hold the "INFORMATION" button and the "HOT" button for at least 3 seconds. The remote
•
will emit a beep and change to 131 °F (55 °C).
Press the "HOT" button to set up to 140 °F (60 °C).
•
Increasing temperature above 140 °F (60 °C)
Press the "HOT" button to set 140 °F (60 °C).
•
• Press and hold the "INFORMATION" button and the "HOT" button for at least 3 seconds. The remote
will emit a beep and change to 158 °F (70 °C).
Press the "HOT" button to set up to 167 °F (75 °C).
•
The temperature options
99 100 102 104 106 108 110 111 113 115 117 122 131 140 158 167
*The remote (9007666005 (TK-RE02)) can display only by degree Fahrenheit.

GENERAL

the suitable temperature water.
TEMPERATURE SETTINGS
-With remote controller-
34
Page
Normal Operation
temperature.
3. Close the hot water tap.
9007666005 (TK-RE02)
"INFORMATION" Button
"COLD" Button
Owner's Guide
HOT
"HOT" Button
"OPERATION" Button
(Unit: °F)*