Connect the elements of your system as follows:
• Plug your PC into the mains outlet to ensure grounding, but keep the power
switched off.
• Connect the Detector Head to the Controller Card using the Cable provided.
The 36-way connectors on the cable are polarized so that there is only one way of
installing the cable. It is important that this cable is securely fastened to provide a
good grounding between the detector head and Controller Card.
Your system has been supplied with a Power Supply Block (PSB) for cooling.
The PSB connects to the detector head via a 2.1mm Jack plug, and to the mains
electricity supply with a standard three-pin plug, or the equivalent plug for your
location.
There is only one socket on the detector head that the PSB can be
connected to. For best performance the PSB should be plugged into the same
power source as the computer.
Windows Operating Systems (95/98/2000/XP/ME)
With
•
During the start up sequence the operating system will detect the Andor plug-in
card and a Dialog box will prompt you for the location of the device driver. Insert
the Andor CD and navigate from the Dialog box to the Setup Information File
(atmcd.inf). Select the device driver file and click OK.
•
The 'installation wizard' now starts. (If it does not start automatically, run
\setup.exe on the CD.) Follow the on-screen prompts. Remove the CD and then
restart the computer to complete the installation.
•
Run the Andor application: from the PC's desktop select
Start...Programs...Andor iXon
•
You are ready to make a data acquisition....
Windows NT...
With
.
. .
...Andor iXon
INSTALLING THE SYSTEM
Connecting the System
Installing the Software
Page 22
Section 2 . 3