Figure 3.4: Command Line Interface; Commands Level; Table 3.1: Command Level - Advantech EKI-7659CPI User Manual

After you have logged in to the system, you will see a command prompt. To enter CLI management interface,
type in "enable" command.
The following table lists the CLI commands and description.
3.1.1

Commands Level

Table 3.1: Command Level

Modes Access Method
Begin a session with
your switch.
User EXEC
Enter the enable
command while in
Privileged user EXEC mode.
EXEC
Enter the configure
Global command while in
configuration privileged EXEC
mode.
Enter the vlan
database command
VLAN database
while in privileged
EXEC mode.
Enter the interface
command (with a
specific interface)
Interface
while in global
configuration
configuration mode

Figure 3.4: Command Line Interface

Prompt
switch>
switch#
switch(config)#
switch(vlan)#
switch(config-if)#
27
Exit Method About This Model
Enter logout or quit. The user commands available
at the user level are a subset
of those available at the
privileged level.
Use this mode to
• Perform basic tests.
• Display system information.
Enter disable to exit. The privileged command is the
advance mode
Use this mode to
• Display advanced function
status
• save configuration
To exit to privileged Use this mode to configure the
EXEC mode, enter parameters that are going to
exit or end be applied to your switch
To exit to user EXEC Use this mode to configure
mode, enter exit.
VLAN-specific parameters.
To exit to global Use this mode to configure the
configuration mode, parameters for the switch and
enter exit. Ethernet ports.
To exist to privileged
EXEC mode, enter
exit or end.
Chapter3