Trunk Commands Set; Table 3.5: Trunk Commands Set - Advantech EKI-7659CPI User Manual

bandwidth type all
bandwidth type broadcast-multicast-
flooded-unicast
bandwidth type broadcast-multicast
bandwidth type broadcast-only
bandwidth in
[Value]
bandwidth out
[Value]
show bandwidth
state
[Enable | Disable]
show interface configuration
show interface status
show interface accounting
no accounting
3.1.5

Trunk Commands Set

Table 3.5: Trunk Commands Set

Commands
aggregator priority
[1~65535]
aggregator activityport
[Group ID]
[Port Numbers]
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
EKI-7659CPI_Manual_ed33
Set interface ingress limit frame
type to "accept all frame"
I
Set interface ingress limit frame
type to "accept broadcast,
I
multicast, and flooded unicast
frame"
Set interface ingress limit frame
type to "accept broadcast and
I
multicast frame"
Set interface ingress limit frame
type to "only accept broadcast
I
frame"
Set interface input bandwidth. Rate
Range is from 100 kbps to 102400
I kbps or to 256000 kbps for giga
ports,
and zero means no limit.
Set interface output bandwidth.
Rate Range is from 100 kbps to
102400 kbps or to 256000 kbps for
giga ports,
and zero means no limit.
Show interfaces bandwidth control
I
Use the state interface
configuration command to specify
the state mode of operation for
I
Ethernet ports. Use the disable
form of this command to disable
the port.
show interface configuration status
I
show interface actual status
I
show interface statistic counter
I
Clear interface accounting
I
information
Level Description
Set port group system priority
G
Set activity port
G
Assign a trunk group with LACP
active.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
G range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
[Workport]: The amount of work
ports, this value could not be less
than zero or be large than the
amount of member ports.
30
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast-flooded-unicast
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-only
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
switch(config)#interface fastEthernet 2
switch(config-if)#state Disable
switch(config)#interface fastEthernet 2
switch(config-if)#show interface configuration
switch(config)#interface fastEthernet 2
switch(config-if)#show interface status
switch(config)#interface fastEthernet 2
switch(config-if)#show interface accounting
switch(config)#interface fastEthernet 2
switch(config-if)#no accounting
Example
switch(config)#aggregator priority 22
switch(config)#aggregator activityport 2
switch(config)#aggregator group 1 1-4 lacp workp
2
or
switch(config)#aggregator group 2 1,4,3 lacp
workp 3